Teeme luugile vorme / making mold for the hatches
Mõtled küll, et luuk on üks lihtne vorm aga kui hakkad täpsemalt uurima, siis esimene serv kaardub 2cm, tagumine 1cm. Kõik see peab äärtest 15 kraadise nurgaga sissepoole vähenema jne. Ja lõpuks on kõik 3 mõõtmeline. No hetkel möllan vormiga. Luugi tegemiseks läheb 3 vormi. Luugi ülemine pool, alumine pool ja lisaks veel krae kuhu luuk sisse käib. Luugi ülemise ja alumise poole sisse läheb vaht. Lasin just pritspahtli peale. Näis kuidas välja tuleb. Päris põnev tegelt.
You do think the hatch is a simple form, but if you start to explore more precisely, the first edge curves 2cm, the rear 1cm. All edges must decrease inwards at an angle of 15 degrees, etc. And finally, all 3 dimensions. Well, right now, I’m messing with the form. It takes 3 forms to make a hatch. The upper half, the lower half, plus the collar where the hatch goes in. I pore foam into the upper and lower half of the hatch. I just put on a splash plaster. See how it turns out. It’s pretty exciting.







