Trennita tugevaks
Geting strong without the workout

Teeme paadi tugevaks / Let’s make the boat strong

Esimene tugevdusribi saigi paika. Tegevus käib nõnda, et paadikese seinale tuleb 3 × 600 g/m² ühesuunalise klaasriide riba. Sellele läheb paksendatud vaiguga 2 × 300 g/m² matist karp, mille külgedele lamineeritakse 90° ja ±45° klaasriiet ning matti vaheldumisi, lõpetades üle ühe kihi siseküljel, nii et saaks ca 6 mm paks. Selle salongipoolsele küljele veel 3 riba 600 g/m² UD-d ja siis kauniduse pärast veel üks kiht matti. 

Sellised karbid tulevad mõlemasse poordi ja lisaks veel üles vendrite vastusurveks ja vööri flooride asemele.

2 päeva ja 30 kg vinüülestrit, 5 kg epovaiku. Karbid said tugevaks lamineeritud. Kiiluraam paika ja verstapost: esimesed vaheseinad.

The first reinforcing stringer is in. Here’s the process: three strips of 600 g/m² unidirectional glass on the hull, then a box section made from two layers of 300 g/m² chopped-strand mat, bonded on with thickened resin. The sides are built up with alternating 90° and ±45° glass and mat, staggering the layers on the inner face, to about 6 mm thick. Three more strips of 600 g/m² UD on the cabin-facing side, then a final layer of mat to make it pretty.

These box sections go along both sides, with more higher up to take the fender loads and up forward in place of the floors.

Two days, 30 kg of vinyl ester and 5 kg of epoxy. The boxes are properly laminated now. Keel frame in place, and the next milestone: the first bulkheads.