Prosta aknad / Micro tough windows

Klaasidest ja raamidest. About glazing and frames

Prostad selles mõttes, et lahti nad ei käi. Akende avamine oleks liiga keeruline.

3 korda mõõda ja 1 kord saada DWG-d. Protsess käis nõnda, et tegime kõigepealt papist šabloonid. Siis viskasin need CNC-laua peale, panin tsangi kena peenikese V-freesi ja kompasin selle peenikese otsaga šablooni kõik olulised nurgad. Panin kõik koordinaadid kirja. Siis kobisin oma koordinaatidega käädi ja tekitasin sinna samasugused punktid. Nüüd polnudki muud kui tõmmata punktide vahele jooned, anda kogu värgile 3 mm sissepoole offset ja voilaa.

Igaks petteks lõikasin veel ka kujud papist välja ja proovisin kontakti reaalsusega. Kõik klappis.

Aknad muidu on safety glass ehk karastatud klaasist. Esiaknad 12 + 15 + 8 mm ja küljeklaasid 8 + 15 + 6 mm. Täidetud argooniga. Valmistas need Mareplex, kelle pakkumine oli ca 40% soodsam kui GlassArtil.

Paigalduseks tuleb veel ka raamid teha. Ma ei viitsi eraldi vormi teha, nii et võtan need samad paketid ja teen igast küljest natuke jämemaks. Selleks tõin IGEPA-st 3 mm PETG-plasti ja kuumpainutan sellest ribad pakettidele ümber. Raamid tulevad L-kujulised. Lõikan raamide järgi augud sisse ja tabin kinni. Vahe pressin siis plöga täis ja nõnda ta jääbki. Aga jah, nüüd tuleb veel 9 raami teha.

Basic in the sense that they don’t open. Opening windows would make life far too complicated.

Measure three times, send the DWG once. First, we made cardboard templates. Then I chucked them onto the CNC table, put a nice fine V-cutter in the collet and used its tip to probe all the important corners. Wrote down the coordinates. Then I took my coordinates into CAD and plotted the same points. All that remained was to join the dots, offset the whole lot inwards by 3 mm and voilà.

Just to be on the safe side, I also cut the shapes out of cardboard on the CNC and checked their relationship with reality. Everything fitted.

The windows are made of toughened safety glass. The front units are 12 + 15 + 8 mm and the side units 8 + 15 + 6 mm. Argon-filled. Mareplex made them; their quote was about 40% cheaper than GlassArt’s.

I still need to make the frames for installation. I can’t be bothered making a separate mould, so I’ll use the glazing units themselves and build them up a little on each side. I bought some 3 mm PETG sheet from IGEPA and will heat-bend strips around the units. The frames will be L-shaped. I’ll cut the openings to match and glass the frames in. Then I’ll squeeze goo into the gap between the frames and the glazing, and there we are. Except, yes, I still have nine frames to make.