Targa laminaat
Laminating the targa arch

Järgmisel nädalal läheb targa kaare lamineerimiseks. Või õigemini esialgu pean küll plugi mõnusaks siledaks saama. Aga jah, mõtlesin laminaadi skeemi välja. Muu on olemas, aga ühesuunalist carbon’it pidin poest juurde tooma. Mõtlesin pikalt, kas panna carbon või klaas (UD-klaasi mul on), aga südame rahustuseks jäin lõpuks ikka carbon’i juurde. Targa võtab groodi jõu enda kanda ja see võib päris märkimisväärne olla.

Kaare sisse teen mõned riiulid, kuhu saab piksnoksli ja telefoni laadima panna. Neid riiuleid on mul ka sellepärast tarvis, et pean kaare põhjast saama kinnitused kinni keerata. Vastavad roostevabad rakised on mul juba olemas. Riiulid teen hiljem klaasist ja need tulevad sellised õhukesed ja kerged, kummivõrguga väljast. Mõtlesin alguses, et panen kõllid ka targa kaare sisse, aga ei saa, sest kompass on lähemal kui meeter. Mittemagneetilised kõlarid on aga nõnda kallid, et neid ei raatsi osta.

Lamineerimisprotsess peaks nõnda käima:

  1. Lamineerin ülemise poole 2 mm paksuseks. Lasen sellel ära kõveneda.
  2. Panen külgedele kile ja lamineerin sellele alumise poole, kõik 3 mm. Lasen sellel ära kõveneda.
  3. Siis tõmban alumise poole lahti ja lõhun plugi ülemise poole seest välja. Lamineerin sisse millimeetri juurde.
  4. Teen nurgad ja liimin paika alumiiniumlati.
  5. Liimin pooled kokku.
  6. Pahteldan ja viimistlen.

Next week, I’ll start laminating the targa arch. Or rather, first I have to get the plug nice and smooth. Anyway, I’ve worked out the laminate schedule. I’ve got everything else, but had to buy some more unidirectional carbon. I spent ages deciding between carbon and glassfibre — I’ve got UD glass in stock — but settled on carbon for peace of mind. The targa takes the mainsheet loads, and those can be pretty substantial.

I’ll build a few shelves into the arch for the binoculars and for charging a phone. I also need the openings to reach the fixings at the bottom of the arch. The stainless-steel brackets are already made. I’ll make the shelves in glassfibre later: thin and light, with elastic netting across the front. I’d thought of putting speakers in the targa too, but the compass is less than a metre away. Non-magnetic speakers cost so much that I can’t bring myself to buy them.

The laminating process should go like this:

  1. I’ll laminate the upper half to a thickness of 2 mm and let it cure.
  2. Then I’ll cover the sides with plastic film and laminate the lower half to its full 3 mm thickness. Let that cure too.
  3. I’ll release the lower half, break the plug out of the upper half and add another millimetre of laminate inside.
  4. I’ll reinforce the corners with UD carbon.
  5. I’ll bond in the aluminium bar for the mainsheet track bolts.
  6. Then I’ll bond the halves together, fair, paint and polish.