Võitlused märja sumpsiga / Wrestling with the wet exhaust
Mitte ükski asi ei lähe lihtsalt. No tegelt võiks ju olla nii, et tellid jupi, kruvid külge ja valma.
Tellisin millalgi suve alguses oma Perkinsile märja sumpsi. Tegelt tal küll on juba soojusvaheti, aga heitgaase ei jahutanud miski, nii et otsustasin päris merelise jupi osta.
Vanakooli mootor, tarneajad on pikad. Eile siis jõudis pakk kohale. Hakkasin kohale sättima, aga ei klapi. Segavaks faktoriks osutus õhuvõtukollektor. Kruvisin ta siis küljest ja nõnda mahub kenasti. Oeh. Tuleb välja, et Perkinsile tehti 7 erinevat õhuvõtukollektorit. Kusjuures minu oma on kaheksas. Tootekood on kenasti alumiiniumvalu sees, aga kataloogid ütlevad, et sohipoeg, ja omaks ei tunnista. Eks siis tuleb võtta käärid ja liim ehk relakas ja keevitus ning olemasolev jupp natuke parajamaks teha. Kui ta üldse keevitub. Või siis lihtsalt eBayst uus osta.
Nothing ever goes smoothly. Surely it ought to be possible to order a part, bolt it on and be done with it.
I ordered a wet exhaust for my Perkins sometime at the beginning of the summer. It already has a heat exchanger, but nothing was cooling the exhaust gases, so I decided to buy the proper marine bit.
Old-school engine, long delivery times. The parcel finally arrived yesterday. I went to fit it. Doesn’t fit. The inlet manifold was in the way. Took that off, and the exhaust fitted beautifully. Sigh. Apparently, Perkins made seven different inlet manifolds. Mine is the eighth. The part number is cast quite clearly into the aluminium, but the catalogues call it an illegitimate child and refuse to acknowledge it. So out come the scissors and glue — or rather, the angle grinder and welder — to make the existing part a bit more accommodating. If the thing will weld at all. Or I could just buy another one on eBay.


