Hakkasime targa kaart tegema / Making the mainsheet arch
Kõige parema tulemuse saab siis, kui plugi teha otse kohapeal. Nii tuleb kõik kõige täpsem. Ei ole mingit digivahet, kus detailid on ideaalsed. Päris elu on ju nii, kuis on.
OK, igal juhul keevitasin ma terasest väikse raamikese, mis targa kaare hõlmu natuke jäigemana hoiaks, ja hakkasin selle ümber MDF-plaati liimima. Suht sirged pinnad, CNC-ga lõigata polnud justkui mõtet. Ainult ümmarguse süvendi, kuhu tuleb paadi logo, lõikasin CNC-ga.
Kuna tegu on jälle 3D-detailiga, siis panen ta kokku alumisest ja ülemisest poolest. Lamineerin alguses paar kihti ülemist poolt, siis panen kile vahele ja lamineerin ära kogu alumise poole. Loodetavasti saan ta kenasti kile küljest lahti. Võtan siis ülemise poole vormi pealt maha ja lamineerin seestpoolt tugevaks. Nurgad teen vahuga tugevaks. Üles talale ja nurkadesse teen Airexist ja UD-süsist raami, mis kogu jõu enda kanda peaks võtma.
Siis panen pooled jälle liimiga kokku, viimistlen ja ongi tehtud.
No eks sellest protsessist saab veel 10 postitust teha.
The best results come from making the plug in place. That way, everything fits properly. No digital world in between, where all the parts are perfect. Real life is what it is.
Anyway, I welded up a little steel frame to keep the legs of the targa arch reasonably rigid, then started sticking MDF around it with hot-melt glue and foam I can use at −10°C. The surfaces are fairly straight, so CNC cutting seemed a bit pointless. I only used the CNC for the circular recess where the boat’s logo will go.
As it’s another three-dimensional part, I’ll make it in upper and lower halves. First, a couple of layers on the upper half, then plastic film in between, then the full thickness of the lower half. Hopefully it’ll release nicely from the film. Then I’ll take the upper half off the plug and build up the laminate on the inside. I’ll reinforce the corners with foam. An Airex and UD-carbon frame along the top beam and through the corners should carry all the loads.
Then I’ll bond the halves together, finish the surface, and done.
Well, there should be another ten posts in that process.




