Teeme suure luugi vorme. Making moulds for the big hatch
Vööri tuleb mul laoruum ja selle lakke tuleb suur kast. See kast on korraliku luugiga, aga dreeniva põhjaga. Võib-olla ma panen sinna suletava korgi, nii et lahtise luugiga oleks võimalik tekil vanni võtta.
OK, praegu on tegemisel suur luuk. Väikse luugi vormid ma tegin MDF-ist, välja arvatud pealmine pool. Uued vormid teen kõik penost. Lakkisin peno epoga ära. Kahele panin veel tavalist peent seinapahtlit alla. See töötas nagu paremini. Nüüd läheb pritspahtel, lihvimine ja poleerimine.
Vähemalt ei pea neid vorme kraanaga tõstma.
The bow will be one big storeroom, with a large locker let into its ceiling for fenders and accessible from the deck. The locker has a proper hatch but a draining bottom. Perhaps I’ll fit a plug as well, so I can open the hatch and have a bath on deck.
Right, I’m making the big hatch now. I made the small hatch moulds out of MDF, apart from the upper half. The new moulds will all be foam. Styrene dissolves the foam, so I sealed it with epoxy. On two of them, I put ordinary fine wall filler underneath as well. That seemed to work better. Next comes spray filler, sanding and polishing.
At least these moulds don’t need a crane to lift them.



